page 2
  
SO-CAL Speed Shop Brake Line Kit Installation Instructions - continued


  • STEP 11:
    Install the line between the red residual valve and the proportioning valve.
  • STEP 12:
    Install the short kinked line to the rear brake line tab.
  • STEP 13:
    Install the brass Tee fitting to your axle housing. SO-CAL axles come pre-drilled and tapped. If your axle is not drilled you’ll need to drill it 25/64” and tap it 7/16-20.
    Note: The Tee fitting is held in place by a special SO-CAL vent tube needed to vent the axle. You’ll need to run a hose up out
    of the way to prevent the oil from siphoning out.
  • STEP 14:
    Install the fixed lines that run from the Tee fitting to the rear brake drums.
  • STEP 15:
    Once all the lines and components have been temporarily installed you can install the line clamps. Carefully choose the position for your clamps to avoid other components.
  • STEP 16:
    Mark the position of the line clamp with a center punch.
  • STEP 17:
    Drill a #21 pilot hole.
  • STEP 18:
    Tap the hole 10-32.
  • STEP 19:
    Blow away any chips and oil.
  • STEP 20:
    Screw the line clamp into position.




   
   


SO-CAL Speed Shop’s
just published 116
page catalog features
over 1,000 world-class
hot rod parts together
with our renowned
clothing designs and
lots of fresh gift ideas.

Over 100 new items!

Preview our catalog
online by clicking
HERE.

Buy the complete
catalog HERE.

Catalog Rebate
When you place your
product order,
enter coupon code
SOC50021R
and we will credit
your order for
the catalog price.


Patton's Inc. - Distributor of air compressors, valves. Also, compressor rental, valve repair and rebuilding services

Baileigh Industrial - Your one stop for all of your metal fabrication needs. Specializing in tube and pipe bending equipment, coldsaws, bandsaws

Speed By Spectre logo

Bend Pak - Your source for car lifts, scissor lifts, automotive lifts and car lifts.

copyright 2006 SO-CAL Speed Shop ®
Go to beginning